Reviews for Mountain - Braking - Disc Brake Hoses

  • Eddy Buckpitt

    Posted on 7 December 2013 about Olive and Insert Kit

    5 stars
    A really good product (the same as shimano avid etc) A product that is really expensive to buy that should be really cheap. Thank you superstar ! Superstar doing what they do best ! (selling the same products just cheaper !)

  • Pietro Possenti

    Posted on 19 November 2013 about Hydraulic Disc Brake Hose - 4 Layer (3m Length)

    5 stars
    tubi di ottimo materiale. La frenata _ molto potente in quanto il tubo non si deforma minimamente. Solo il materiale leggermente rigido. Ma comunque un ottimo prodotto.

  • Pietro Possenti

    Posted on 19 November 2013 about Disc Brake Hose Fitting Kit Alloy

    3 stars
    The screws included in the kit no. 2 are not good for the brakes avid juicy 7. are too short. I had to use the old ones.

  • Bryan Murphy

    Posted on 18 November 2013 about Disc Brake Hose Fitting Kit Alloy

    5 stars
    Bought the blue kit 2 for my saint M810s, fit perfectly, look great and so light, however they are like the warning says less durable than steel so just be careful tightening them up, there are torque values given for the banjo bolt so no probs there. Do the banjo last and you can eliminate most of the twist in the hose and have them sitting where you want.

  • Mark Gorman

    Posted on 19 October 2013 about Olive and Insert Kit

    5 stars
    Took the gamble of trying these in some Avid Elixir hoses. They've worked a treat, the barb does take some getting in- I had to slightly enlarge the hose with a 2mm hex key. Way cheaper than Avid ones.

  • Aiden Magowan

    Posted on 4 September 2013 about Hydraulic Disc Brake Hose - 4 Layer (3m Length)

    5 stars
    Great looking cable couldn't believe how fast this was delivered, not yet fitted but extremely happy with product!

  • Simon Hague

    Posted on 18 July 2013 about Hydraulic Disc Brake Hose - 4 Layer (3m Length)

    5 stars
    All I can say is Marvellous, one tip for installing the brass insert is to dip the hose into boiling water for a minute in a cup and you can then push the barbed insert into the house so much easier.

  • Duncan Pirie

    Posted on 21 December 2012 about Disc Brake Hose Fitting Kit Alloy

    5 stars
    Perfect, bought the hose and kit. Fitted perfectly and looks the biz.

  • Carl Watson

    Posted on 9 December 2012 about Disc Brake Hose Fitting Kit Alloy

    1 stars
    Purchased a blue fitting kit 2 which is supposed to fit Formula RX brakes (2011 model) but it's not even close. Only bits that fit are the banjo end although the bolt is too short so original stainless silver bolt had to be used. At the lever end the Formula collar has a coarse thread as opposed to the fine thread on the superstar part, but this is an issue i brought up with them with their origin
    Read more...

  • Ian Rickhuss

    Posted on 25 August 2011 about Hydraulic Disc Brake Hose - 4 Layer (3m Length)

    5 stars
    Excellent quality, easy to fit, the only niggle and it is very minor was the rubber shroud that goes over the end of the hose on the Shimano fitting kit was quite loose but swapped it back for the Shimano original. Well done again Superstar!!!

Review By Category

Archive