Reviews - March 2014

  • Sven Vucic

    Posted on 20 March 2014 about 4 Pack Kevlar Disc Brake Pads

    5 stars
    Brake setup: Shimano Zee brakes Avid HS1 200/180mm rotors (F/R) originally came with Shimano Resin without radiators In short, they were just as good as the original Shimano Resins. Strong bite and great modulation on both pads (Superstar Kevlar and Shimano Resin), silent in most conditions (see below). Rode them in winter, mud and now in dry hot weather. Excellent performance in all condit
  • Keith Neal

    Posted on 14 March 2014 about Type 2 - Headset Bearings 1.5" or Tapered 45x45 Degree x1

    5 stars
    fitted my lower headset bearing on my cayon nerve AM7 2012 , had trouble finding replacment this slots straight in and its cheap
  • Phil Jake Ed Morton

    Posted on 12 March 2014 about Type 4 - Headset Bearings 1.5" or Tapered 36x45 Degree x1

    5 stars
    Ordered Tuesday delivered Wednesday - free! superb service again. This bearing will need renewing annually if you ride a lot, no amount of lubing, regreasing and maintenance will stop all the dirt, water and crap getting into this bearing. It is direct line of fire. This bearing is a direct replacement for the bottom FSA bearing I had in my Trek 9.7 2011 (carbon frame) with Fox 32 Talas tapered
  • Charlie Jones

    Posted on 4 March 2014 about 4 Pack Kevlar Disc Brake Pads

    3 stars
    Good in summer but appalling in winter. DO NOT BUY IF RIDING IN WET/MUDDY CONDITIONS as they wore out in less that one ride when it was muddy. However I would rate in the summer as they last for a decent time in dry conditions.
  • David Hayward

    Posted on 2 March 2014 about Pair of Superfly Carbon-Ti Ultralight QRs 135mm - GOLD ONLY

    1 stars
    Almost killed my Blue Pig. This skewer has very little clamping force compared to a decent one. New build, I'd checked the skewer was tight before we set off, and on a gentle climb my bike spat the back wheel out, twisting the area of plate around the brake side dropout. Luckily the frame is steel, but it took an hour from my LBS then an extra hour of tweaking from me to get the frame true with

Review By Category