Elite Barends

£19.99
Plenty in stock



Shout about this product!

Description

We set out to design beautiful ultralightweight bar ends to keep both your handlebars and yourself safe. Ugly plastic or rubber push in barends work fine but these are a work of art and a fraction of the weight. Nobody likes implaing themselves on an open ended handlebar, you can look good at the same time with these CNC barends.

Superstar Elite bar ends are manufactured in our UK CNC machine shop to ultrafine precision and finish, on our Swiss lathes. With an innovative clamping wedge design to securely grip on the inside of your bars. The kit is supplied with 2 sets of O-rings to customise to your bar.

 

Fitting range:

Fits standard 22.2mm OD handlebars. Internal bore dimentions must18.5mm or larger, ie any quality aluminium or handle bar.

 

Fitting instructions:

  1. Fit the largest O-ring with with the cone fully wound out
  2. Test the barend fits in the end of your bar
  3. If too large fit smaller O-ring
  4. Slide in fully and tighten to expand. NOTE Reverse thread!


Reviews