Disc Rotor - Vibe Design
Description
A standard disc rotor with six bolt fitment available in 160mm, 180mm and 203mm sizes. Manufactured from stainless steel which is heat treated and ground for flatness, the vibe design offers effective braking and air flow around the brake.
Suitabilities
Ultra lightweight components suitable for cross country racing only.
Lightweight parts suitable for off-road cross country riding.
Tough light to mid-weight components designed for off-road trail riding.
Sturdy components suitable for long off-road descents.
Ultra-tough components suitable for the harshest conditions and descents.
Components optimized for aerodynamics and speed.
Light-weight components, designed for maximum performance.;
Reliable components designed for everyday performance.
Sturdy components suitable for off-road, CX racing
Strong components, designed to take heavy loads over long distances.
Tech Specs
- Weight:
- 160mm - 120g
- 180mm - 159g
- 203mm - 198g
- Rotor thickness: 2mm (industry standard)
- Rotor track depth: 17mm
Reviews
-
.jpg)
Brilliant!
Posted on 31 December 2015 by M. Ogley
i've run these rotors on my bike for a season; they're still in brilliant working condition but since i use them for trials i replace them for my own peace of mind. my braking needs are very different to everyone elses on here but that doesn't stop me from being critical about these rotors; i need my brakes to work like an on/off switch, modulation is far less critical. That said they delighte -
Alexander Whittaker
Posted on 26 February 2014
Great product I have been using these for years now (approx. 3). Better wear rate than stock shimanos and cheaper too. Run them on all my bikes, 4 discs and not one problem. 1 bike with 1000km all off road 1 bike with 4000km on and off road still on original sets -
Steve Dawson
Posted on 14 August 2013
Has a high or low spot on the braking surface which causes the brake to snatch. Should have kept to Avid!! -
Tom Jarvis
Posted on 23 August 2012
Check thickness before fitting. Disc measured 0.15mm thicker than Avid standard. Caused rubbing. Might be ok on other brands but not Avid. Superstar Edit - This is incorrect, they are surface ground to the standard 2mm most brake manufacturers use including avid. If your pads rub you need to push back your pistons and bleed/service your brakes. -
Russell Stroud
Posted on 29 July 2012
just got back from the megavelanche in the alps and the disc perfomed faultlesly great product
